2 Inch 52mm Electronic Car Fuel Level Gauge with LED Display, China Suppliers & Factory for 12V/24V Vehicles
Item Description
This fuel level gauge has a delay function circuit that does not cause flickering of the LED display because the tank is sloshing during driving. Blue LED can be clearly shown in strong sunlight.
The gauge is fit to a resistance type fuel level sensor, and the measuring range of the sensor is ≤ 2KΩ.
It can be adjusted to fit your car.
Introduction
Wiring Instructions
- 1 Red wire: connected to ignition switch ACC
- 2 Green line: fuel level sensor signal line
- 3 Black wire: battery negative electrode
Setting Description
- 1 Press and hold the key for 3 seconds to enter the low oil level setting: the lowest LED flashes. At this time, push the oil sensor to the lowest position and press the key once (set the lowest oil level value).
- 2 The gauge enters the high oil level setting: the highest LED flashes. At this time, push the oil sensor to the highest position and press the key once (set the highest oil level value).
- 3 The gauge enters the normal working mode after completing the setting: the LED scans from the lowest position to the highest position once and then enters the normal working mode to display the current fuel level.
Fitment & Package Options
Universal Fit: Suitable for all 12V/24V Cars.
- 1 * Fuel Level Gauge
- 1 * Power Cable
- 1 * Fuel Level Gauge
- 1 * Power Cable
- 1 * Fuel Level Transmitter
- 1 * Oil Float
- 1 * Rubber Pad
- 1 * Bolts Pack
Frequently Asked Questions
No, this fuel level gauge features a built-in delay function circuit that prevents the LED display from flickering due to fuel sloshing in the tank while driving.
Yes, the gauge is equipped with a bright blue LED display designed to be clearly visible even under strong sunlight.
This gauge is compatible with resistance-type fuel level sensors with a measuring range of ≤ 2KΩ, with a standard specification of 240-33 Ohm.
The gauge features a universal fit and supports an operating voltage of 9V to 36V, making it suitable for all 12V and 24V vehicles.
The wiring is straightforward: connect the Red wire to the ignition switch ACC, the Green wire to the fuel level sensor signal line, and the Black wire to the negative battery electrode.
It depends on your needs. The package is available in two options: one with the sensor and fuel float accessories, and one without the sensor if you already have a compatible unit installed.